Single Skin Metal Roof

Designed to be provide an economical solution where performance demands are moderate.

To Pitch Roof

Single skin metal roof uses only 1 metal deck sheet and is designed to provide an economical solution, normally used in applications where performance demands are moderate. Insulation for single skin metal roof is installed below the metal cladding sheet held by aluminum foil and steel wire mesh rolled over purlins.

Its uniquely formulated coated stone wool fibres are able to effectively repel rain water that comes into contact with the product, hence reducing the potential of damage and wastage during installation.

Cool ’n’ Comfort insulation satisfies key performance requirements to improve the indoor temperature, reducing exterior noise and fire protection of the entire system.

In the tropical climate, thermal performance of the roofing system is critical as a substantial amount of heat gain is absorbed through the roof. Cool ’n’ Comfort RL series is the ideal thermal insulation solution as the flexible insulation roll allows for installation on roof over long length and is flexible enough to accommodate the compression over the roof fixing clips.  

Its uniquely formulated coated stone wool fibres are able to effectively repel rain water that comes into contact with the product, hence reducing the potential of damage and wastage during installation.

With the increasing demands in building codes to improve building thermal comfort, 100mm thickness of Cool ’n’ Comfort RL940  insulation in single skin metal roof can achieve U-value of 0.34W/m²K to meet the requirements of Malaysia Green Building Index for Residential New Construction for construction to be less than 0.4W/m²K. Apart from thermal performance, this non-combustible insulation also complies with most building requirements on reaction to fire for roofing materials.

Sports Hub Singapore

Related pitch roof solutions

Products

Thickness (mm)

Width (mm)

Length (mm)